Tips on how to Mod a Xbox 360 elite Controller for Call of Duty 4

"Modern Warfare," the 4th installment within the "Cod" game series, broke sales records following rrt had been released. "Modern Warfare" marked a departure on the The second world war themed games from the previous games as it allowed gamers to fireplace weapons depending on actual military equipment. Those weapons get back stronger with a xbox 360 wireless controller modification that creates a rapid fire attack.

Instructions

1. Click on the tab to get rid of and set aside the battery compartment within the underside in the controller. Remove all seven screws that support the shell together (three take presctiption they can be kept on the battery compartment with one underneath). Maybe you have to work with the flathead screwdriver to pry the tape from the final screw.

2. Tape all four colored buttons on the controller face (this prevents the buttons from shifting), and gently pry the controller's shells open. Eliminate the small rubber plate from beneath the buttons and discard.

3. Remove each thumbstick and hang up aside. Get the small dark circular three pronged patch above the disc-shaped rumble pack for the right side from the open controller: the first soldering point is often a small zigzag shaped silver line. A compact silver point just above the same circle near around the left side from the controller will be the 2nd soldering point.

4. Cut 4 inches of ribbon wire. Cut the guts point between your wires and gently pull both different colored wires apart. Crimp the ends of each one wire in regards to a quarter inch to reveal fresh wire. Thread the tip of a single exposed wire through on the list of prong holes at the base with the push button and coil it throughout the prong. Do the identical for that other wire.

5. Pry the control panel out of the bottom part from the controller's shell. Pick the area for the controller where you want the push to get placed (reliant on preference). Drill an opening on the controller's top shell as a possible attachment point for that push.

6. Solder the residual exposed end to the first soldering point, then solder the final with the other wire onto your second soldering point. Permit the newly soldered joints for cooling for around a couple of hours, then reassemble the control within the reverse order during which you took it apart and replace the battery compartment.

Xbox Intec Controller Instructions

Responding towards the unusually large original Xbox controller, quite a few third-party controllers were released that have been not merely less space-consuming than the first controller, and also boasted additional advantages. The Intec Pro Mini 2 controller were built with a volume of additional features, say for example a turbo feature plus a programming feature. This controller, identical to the original Xbox controller, is fairly easy to use.

Instructions

1. Connect the Intec controller to a single from the controller ports about the front of the Xbox console.

2. Hold among the program buttons down, then press any mixture of buttons. Each and every time you press this program button, the combination of buttons will probably be re-executed.

3. Hold down the "Turbo" button, then hold down on the list of other buttons as a way to activate the "Turbo" function with the button. In "Turbo" mode, the overall game will not register that you'll be holding the button down, but pressing it rapidly.

4. Set the vibration control activate the controller with the idea to 1, 2, or off. The larger the telephone number, the stronger your controller's vibration are going to be.