Replace the Shell over a Nintendo ds lite Lite

The Ds lite Lite is a gaming device that gives portability for players to take pleasure from a common games on the go. The Ds lite by nintendo incorporates a built-in backlight behind the LCD so gamers can enjoy at night, a lot improved feature from the regular Nintendo ds lite predecessor. However, portability could mean disaster in the event the device is accidentally dropped or crushed. With some tools plus a new ds lite housing case, which may be purchased at a third-party online retailer, your Nintendo ds lite Lite can look good as new. Online stores is found by searching "Replacement Ds lite by nintendo Shells" or browsing eBay.

ds lite shell

ds lite shell

1.Remove any Nintendo DS games through the cartridge slot. Eliminate the battery cover to obtain battery.

2.Eliminate the six tri-wing screws on the bottom with the device that has a tri-wing screwdriver. The bottom of the shell should easily be removed with all the tri-wing screws out.

3.Locate the black clamp on the back edge on the bottom of the device. Open the clamp by swinging it up and taking out the bus.

4.Obtain the brass connector, which can be perfectly found on the middle of the bottom in the device. Pull against eachother gently as it ought to be attached to a black wire.

5.Unscrew the hinge cover from the bottom of one's Ds lite by nintendo that has a Phillips-head screwdriver. Unscrewing the hinge cover will assist you to take away the the surface of the ds lite shell.

6.Eliminate the rubber covers on the top shell to reveal four screws. Remove these using your Phillips-head screwdriver.

7.Get a small slit through the top shell. Start using a small flat screw driver and run it across the slit till the upper layer on the top shell is taken away.

8.Apply constant pressure to the hinge as you get rid of the DS Lite's top shell. Using the hinge dismantled, connect the bus using the black wire you removed from the clamp in steps 3 and 4. Take a new replacement shell bottom and place it back beneath the Nintendo ds. Make use of your tri-wing screwdriver to screw the six tri-wing screws back to place.

9.Unscrew the 2 circuit boards and everything in to the new top shell. Examine carefully the layout of all of the components when putting transferring the constituents towards new housing.

10.Fix the metal hinges to its original position and plough on the hinges until the top shell fixates itself while using the hinges.

11.Re-attach the bus and wire over the new ds lite housing case slot. Clamp down the bus and make sure the buttons are fastened tightly from the new shell. Confirm the power and charge light to make sure they may be of their original places inside the shell.

12.Screw and snap the highest and bottom pieces of the shell back together.