Nintendo DS Case Replacement Instructions

If the Ds lite includes a broken hinge or possibly a cracked or scratched shell, it may be important to replace the console's ds case. Alternatively, maybe you've happened upon a whole new DS case ( http://www.vdealbox.com/ds-accessories/ds-housing-shell-case.html )that you choose the look of, and you would like to apply it to house your console from now on. No matter what, dismemberment and moving the inner workings of the Ds lite is challenging, nevertheless for an adventurous user you never know his way having a screwdriver, it may not be impossible.



Instructions
Disassembling the Original Shell

1. Start the console so that you are looking upon the labels on the bottom in the machine. Unscrew the 5 Phillips and two tri-wing screws at the base face. Be sure to retain all screws for assembling the replacement shell.

2. Take off the bottom shell on the console to reveal the motherboard. Unscrew the 4 Phillips screws and employ needle-nose pliers to disconnect the long cable left on the DS cartridge slot.

3. Open the Nintendo DS and press on the underside screen to pop the screen and motherboard out of your shell. Tend not to damage the foam, tape or adhesive on the back in the top screen; these are vital to reassembly.

4. Unscrew the tri-wing nut revealed by removing the motherboard to disconnect the very best and bottom screens. Place the disassembled bottom screen to at least one side.

5. Work with a flathead screwdriver to pry a few rubber pads from each corner of the DS's top screen. Unscrew the four Phillips screws underneath the pads and lift the leading on the top shell from the screen.

6. Make use of a screwdriver to push the tiny black hinge adjuster outside the hinge channel, retaining the cable looped throughout the hinge. Pry your circuit boards, speakers and top screen. Go slowly, because are attached with a light adhesive.

Transferring with a New Shell

7 . Push the black hinge adjuster, using the screen cable looped around it, in the hinge channel from the new shell. Use channel-lock pliers to push the adjuster into place like the console's original shell.

8. Position the top screen, speakers and circuit boards into your top shell, applying a smaller amount of silicon adhesive to keep them in position. jklzaeqc 1120

9. Close the 2 halves with the top shell and screw it well into place using the four Phillips screws from your original ds cases. Push the rubber pads on the screws.

10. Replace the tri-wing screw near the top of the end shell. Press underneath screen back to place, being careful to keep the foam, tape and adhesive within the back with the screen.

11. Press the motherboard back to place and screw it into your shell. Reconnect the long cable near to the DS console slot.

12. Press the end face in the bottom shell onto the console and replace the seven screws about the back in the machine to accomplish the shell replacement.